The AT25080B-WWU11L belongs to the category of Serial EEPROM (Electrically Erasable Programmable Read-Only Memory) and is commonly used for storing small amounts of data in various electronic devices. This EEPROM offers characteristics such as low power consumption, high reliability, and a wide operating voltage range. It is typically packaged in a small form factor, making it suitable for space-constrained applications. The essence of the AT25080B-WWU11L lies in its ability to retain stored data even when the power is turned off. It is commonly available in tape and reel packaging with varying quantities based on customer requirements.
The AT25080B-WWU11L features an 8-pin configuration: 1. Chip Select (/CS) 2. Serial Data Input/Output (DI/DO) 3. Serial Clock (SCK) 4. Ground (GND) 5. Write Protect (/WP) 6. VCC Power Supply 7. Not Connected (NC) 8. Serial Data Out (DO)
The AT25080B-WWU11L operates by using an electric field to apply voltage to specific parts of the memory cell, allowing data to be written or erased. When reading data, the stored charge in the memory cells is detected, enabling the retrieval of the stored information.
The AT25080B-WWU11L is widely used in applications such as: - Consumer Electronics (e.g., smart TVs, set-top boxes) - Automotive Systems (e.g., engine control units, infotainment systems) - Industrial Control Systems (e.g., programmable logic controllers, sensors)
Some alternative models to the AT25080B-WWU11L include: - AT25128B-WWU11L: 32 Kbit Serial EEPROM - AT24C02C-SSHM-T: 2 Kbit I2C EEPROM - CAT24C08WI-GT3: 8 Kbit I2C EEPROM
In conclusion, the AT25080B-WWU11L Serial EEPROM offers a reliable and efficient solution for data storage in various electronic applications, despite its limitations in storage capacity and write speed. Its wide operating voltage range and small form factor make it a versatile choice for designers seeking non-volatile memory solutions.
[Word Count: 443]
What is the AT25080B-WWU11L?
What are the key features of the AT25080B-WWU11L?
How is the AT25080B-WWU11L typically used in technical solutions?
What are the advantages of using the AT25080B-WWU11L in technical solutions?
What are the typical operating conditions for the AT25080B-WWU11L?
How do I interface with the AT25080B-WWU11L in my design?
Are there any specific considerations for programming or erasing data on the AT25080B-WWU11L?
Can the AT25080B-WWU11L be used in battery-powered devices?
What are some common challenges when integrating the AT25080B-WWU11L into a technical solution?
Where can I find additional resources and support for working with the AT25080B-WWU11L?